Application / Product Range:
• For drawing aluminum or bare/tinned copper wire.
• No. of wires: …………………………………………….. 1 or 2.
Technical data
(we reserve the right to modify technical data and characteristics at any time):
• Wet wire drawing machine for non-ferrous materials.
• Direction of operation: …………………………… Right.
• Maximum operating speed (bare copper): 30 m/s.
• Max. inlet ø mm: …………………………………….. 0.73 with 2 wires.
………………………………………………………………….. 1.02 with 1 wire.
• Min./max. outlet ø mm: …………………………. 0.10 – 0.20 with 2 wires.
…………………………………………………………………. 0.22 – 0.32 with 1 wire.
• Reduction in area between dies: …………… 21 drafts 11.5% (13% elongation).
• Dies dimensions ø : ……………………………….. 12 x 8mm.
• No. of internal wire drawing cones and external ceramic capstans: 4 + 1.
• Silent transmission through flat conveyors.
• The wire drawing compartment and die holders are accessible through a sliding
door, designed to prevent fluid leaks during operation.
• The wire drawing fluid distribution system is performed by pipes and die holders especially designed to ensure the proper dies lubrication.
• Lower tank with capacity for approx. 170 liters of drawing solution with pump
and heat exchanger for cooling and circulation.
• Speed and coiling tension controller dancer (PUR) + Take-up for ø 250mm coil (BOR/250).
• Operating voltage: …………………………….. 380 V. 60 Hz (Other to be confirmed).
Supplementary equipment:
• Wire payoff
• Vertical continuous annealer 100 or 150 A.
• Option for 02 “Controller dancer + take-up” for coiling on 02 spools,
separating the wires.
